! LNX test
MASK/CLEAR
MASK/CLEAR/TIME
PRINT chopper phase 99.9, max wav @ 6m is ~15.75
L/WAV 1.75 15.75 .25/LIN
PRINT 5% wavebins
! strong scatter
L/Q .001 .8 .08/LOG
!L/Q .003,.001,.013,-.08,1.0
PRINT change Q bins if have weak scatter
! weak scatter
!L/Q 0.0025, 0.001, 0.01, -0.16, 1.0
L/QXY 0 0.025 .005/lin
! note increase lower time limit here
!BACK/MON/TIMES 85000 98000
BACK/M1 35000 65000
BACK/M4 0 5000 
DET/REAR
GRAVITY/ON
mask h0
mask h190>h191
mask v0
mask v191
! dead wire near top
mask h156>h159
! spot on rhs beam stop at 11m
! mask h57>h66+v134>v141
!
mask/time 14500 16000
!mask/time 5000 19200
!
L/R 41 -1 3
!L/SP 1 36864
!MON/LENGTH=17.937 2
!
!MON/DIRECT=DIRECT_TRY_3.DAT
MON/DIRECT=DIRECTm1_9672_6m_08Aug11.dat
MON/TRANS/SPECTRUM=1/INTERPOLATE
!  set monitor 2 to interpolate
!PRINT  scale not sorted yet !!
TRANS/TRANSPEC=4/SHIFT=-70
MON/SPECTRUM=1/INTERPOLATE
FIT/TRANS/LOG 1.75 15.75
! 02/08/11 this centre found from glassy carbon 9673-add, 1.75-16.25ang, gravity on
set centre -106.4 -169.1
!
! 29/05/11 .1358, fit 7400 GDW20 using 1.75 to 16.25 (but first 3 points noisy at 8% bins)
!  24/7/11 .1374, very similar, from 9356-add, but data is too steep at small Q, need new D-B?
! 25/07/11 new d-b file using gdw, 0.10327
! 04/08/11 new db 9673gc_6m_SmoothUnFitTrans_04Aug11, .10055
! 04/08/11 DIRECTm1_9346_6m_try_26Jul11, fit to 9672, .0626
! 08/08/11 DIRECT=DIRECTm1_9672_6m_08Aug11, fit 9672, .1005
set scales 0.1005 1.0 1.0 1.0 1.0
! correction to actual sample position, measured 28 before shutter, notionally 81mm before shutter
SAMPLE/OFFSET 53
! Correction to SANS2D encoders in mm 
DET/CORR REAR X -16.0
DET/CORR REAR Z 58.0
DET/CORR FRONT X -44.0
DET/CORR FRONT Y -20.0
DET/CORR FRONT Z 47.0
DET/CORR FRONT ROT 0.0
!
!! 22/07/11 MASKSANS2D.112C_6m_commissioning SANS Team, REAR (ie ex front) only