Ticket #11736: MASKSANS2D_094i_RKH.txt

File MASKSANS2D_094i_RKH.txt, 1.5 KB (added by Anton Piccardo-Selg, 5 years ago)
Line 
1MASK/CLEAR
2MASK/CLEAR/TIME
3DET/FRONT
4GRAVITY/ON
5L/WAV 4.6 12.85 0.125/LIN
6FIT/TRANS/LOG 4.6 12.85
7L/Q .0018, .0003, .01, -.06, 0.1, 0.006, 0.15
8L/QXY 0 0.04 .002/lin
9!BACK/MON/TIMES 80800 98000
10mask h0
11mask h190>h191
12mask v0
13mask v191
14! try this box mask for the streak below beam stop
15mask h58>h64+v125>v130
16!
17!mask/time 14876 17124
18!mask/time 5000 19200
19!
20L/R 41 -1 3
21!L/SP 1 36864
22!MON/LENGTH=17.937 2
23MON/DIRECT=DIRECT_RUN524.dat
24!MON/FLAT=LOQ$DISK0:[LOQMGR.EFFIC]FLAT_CELL.061
25!
26! this centre found RKH 28/11/09 11m front at -100, why is x centre so different ???
27!  run 2403 gave -308 -228.5 but anisotropic ??  gdw20 run 2407 -310.5 -220.5
28!  run 2459 seems more isotropic gave -308.7 -225.2
29! 9/4/10 try again, with gravity, run 2459  -308.5, -198.8
30set centre -308.7 -198.8 5.1 5.1
31!
32! 29/11/09 INTERIM fit 2448  4.6-12.85, 11m, A1=12, A2=5  (need detail overlap check yet)
33! still need a good centre
34set scales 0.2514 1.0 1.0 1.0 1.0
35!
36! correction to actual sample position, 81-47 for steam header, zero corr is 81mm before safety shutter
37SAMPLE/OFFSET 34.0
38! Correction to SANS2D encoders in mm
39DET/CORR REAR X -16.0
40DET/CORR REAR Z 58.0
41DET/CORR FRONT X -44.0
42DET/CORR FRONT Y -20.0
43DET/CORR FRONT Z 47.0
44DET/CORR FRONT ROT 0.0
45DET/CORR/FRONT/RADIUS 1.0
46DET/CORR/FRONT/SIDE 1.0
47!
48!! 29/11/09  Bouchard, front det only, at 11m,   A2=5mm runs, det moved 25mm
49!! scale from fit to .0098 to .334, 6% log bin data, using 1/data wts as errors too large
50!! beware front det will need its own mask