Ticket #2770 (closed: fixed)

Opened 10 years ago

Last modified 5 years ago

In ISIS SANS batch mode the sample geometry is not set in the GUI

Reported by: Steve Williams Owned by: Steve Williams
Priority: critical Milestone: Iteration 28
Component: Mantid Keywords:
Cc: Blocked By:
Blocking: Tester: Michael Whitty

Description

The sample width, height, etc. were being set by the controls on the Geometry tab in the GUI. These controls need to be disabled when batch mode is selected (on the first tab) and not used in the reduction

Change History

comment:1 Changed 10 years ago by Steve Williams

  • Status changed from new to accepted

comment:2 Changed 10 years ago by Steve Williams

(In [10569]) Stop the GUI from overwriting the geometry settings from the workspace re #2770

comment:3 Changed 10 years ago by Steve Williams

(In [10592]) Stop the GUI from overwriting the geometry settings from the workspace re #2770

comment:4 Changed 10 years ago by Steve Williams

(In [10630]) SASNS batch mode remove errors when deleting temporary workspaces re #2770

comment:5 Changed 9 years ago by Steve Williams

  • Status changed from accepted to verify
  • Resolution set to fixed

When batch mode is selected (first page of ISIS SANS GUI) the geometry options are disabled and any values written there have no effect on the results of a reduction. Instructions for re-enabling the geometry tab should be in the tool tip

comment:6 Changed 9 years ago by Michael Whitty

  • Status changed from verify to verifying
  • Tester set to Michael Whitty

comment:7 Changed 9 years ago by Michael Whitty

  • Status changed from verifying to closed

tested in 11062

comment:8 Changed 5 years ago by Stuart Campbell

This ticket has been transferred to github issue ​3617

Note: See TracTickets for help on using tickets.