Ticket #3383 (closed: fixed)

Opened 9 years ago

Last modified 5 years ago

Instrumentview picking bugs: d-spacing on diffraction instruments

Reported by: Nick Draper Owned by: Roman Tolchenov
Priority: critical Milestone: Iteration 30
Component: MantidPlot Keywords:
Cc: Blocked By:
Blocking: Tester: Janik Zikovsky

Description

Initial steps:

  1. load a GEM raaw file
  2. Use AlignDetectors to convert ot d-spacing
  3. Open up the instumenr view and unwrap on z cylinder

Then 3 bugs

  1. The unit label on the bottom still says TOF desipte the values being d-spacing.
  2. Reduce the max integrated x value slightly (to say 60), then use the select whole tube tool. The miniplot is confused, displaying the y axis as -5e+300 to 0
  3. move the max integrated value to the max, and move the min to 1.0. Then pick the select single pixel tool and run over the data, the x axis is blank.

Change History

comment:1 Changed 9 years ago by Roman Tolchenov

  • Status changed from new to accepted

comment:2 Changed 9 years ago by Roman Tolchenov

  • Status changed from accepted to verify
  • Resolution set to fixed

In [13671]:

I think this fixes #3383

comment:3 Changed 9 years ago by Janik Zikovsky

  • Status changed from verify to verifying
  • Tester set to Janik Zikovsky

comment:4 Changed 9 years ago by Janik Zikovsky

  • Status changed from verifying to closed

None of the 3 bugs described are seen.

comment:5 Changed 5 years ago by Stuart Campbell

This ticket has been transferred to github issue 4230

Note: See TracTickets for help on using tickets.