Ticket #3788 (closed: fixed)

Opened 9 years ago

Last modified 5 years ago

Default values for the PeakPickerTool within the Muon Analysis interface

Reported by: Robert Whitley Owned by: Robert Whitley
Priority: major Milestone: Release 2.0
Component: Mantid Keywords:
Cc: Blocked By:
Blocking: Tester: Anders Markvardsen

Description

There are two parts to this ticket.

1) Make sure that when the peak picker tool is on the graph it is set up using the values from the plot options tab. (Start μs) & (Finish μs).

2) If the user changes the workspace then the peak picker tool needs to use the same values as it was using before.

Change History

comment:1 Changed 9 years ago by Robert Whitley

In [14894]:

Refs #3788. Set the PeakPickerTool to have default values within the muon analysis interface. I also made it so that if you change workspace on the data analysis tab then the PeakPickerTool will keep the same values for the new plot.

comment:2 Changed 9 years ago by Robert Whitley

  • Status changed from new to accepted

comment:3 Changed 9 years ago by Robert Whitley

  • Status changed from accepted to verify
  • Resolution set to fixed

comment:4 Changed 9 years ago by Anders Markvardsen

  • Status changed from verify to verifying
  • Tester set to Anders Markvardsen

comment:5 Changed 9 years ago by Anders Markvardsen

  • Status changed from verifying to closed

load data, changed (Start μs) & (Finish μs) setting. clicked on fitting tab, changed range manually, changed to new workspace, changed back again - worked as it should

comment:6 Changed 5 years ago by Stuart Campbell

This ticket has been transferred to github issue ​4635

Note: See TracTickets for help on using tickets.