Ticket #4172 (closed: fixed)

Opened 9 years ago

Last modified 5 years ago

SANS: component moved twice for transmission

Reported by: Anders Markvardsen Owned by: Anders Markvardsen
Priority: critical Milestone: Release 2.0
Component: MantidPlot Keywords:
Cc: Blocked By:
Blocking: Tester: Michael Reuter

Description

When same number for transmission and direct monitors gets moved twice.

Attachments

MASKSANS2D_113H_6m_GISANS_M1_M4.txt​ (1.8 KB) - added by Anders Markvardsen 9 years ago.
mask file
directM1_9672_6m_08Aug11.DAT​ (8.0 KB) - added by Anders Markvardsen 9 years ago.
goes with mask file

Change History

comment:1 Changed 9 years ago by Anders Markvardsen

Fix SANS2D monitors moved twice. Re #4172

Changeset: cae869b5037b37743fff728a7b7d858a8ec01015

comment:2 Changed 9 years ago by Anders Markvardsen

To test load open ISIS SANS GUI. Open mask file and select the same run number for transmission and direct. Go to history. You should see 3 lines of component movement not 6. For mask file see attached. Run number to use is e.g. sans2d 10648 accross the board

Changed 9 years ago by Anders Markvardsen

mask file

Changed 9 years ago by Anders Markvardsen

goes with mask file

comment:3 Changed 9 years ago by Anders Markvardsen

  • Status changed from new to accepted

comment:4 Changed 9 years ago by Anders Markvardsen

  • Status changed from accepted to verify
  • Resolution set to fixed

comment:5 Changed 9 years ago by Michael Reuter

  • Status changed from verify to verifying
  • Tester set to Michael Reuter

comment:6 Changed 9 years ago by Michael Reuter

  • Status changed from verifying to closed

Following the above prescription, I do see that the history shows only three movement calls.

comment:7 Changed 5 years ago by Stuart Campbell

This ticket has been transferred to github issue ​5019

Note: See TracTickets for help on using tickets.