Don't allow the ResultsTable tab to populate its tables with workspaces that have the same parameters

[Robert Whitley]

Currently muon scientists have told us they shouldn't fit anything using different functions (and therefore different parameters).

However if they were to do this the current results table tab will either crash or seem to run normally but populate the final table with wrong information.

A check needs to be done before populating the lists to make sure no parameters tables with different parameters are populated into the tables on the ResultsTable tab.

To replicate crash/wrong information. 1) Load Muon Analysis.

2) Load a few data sets.

3) Using the fittings tab have some workspaces fitted with just Gaussian, then the others fitted using Gaussian and Exp Decay.

4) Click the results table tab.

5) Check to see if workspaces listed all have the same parameters.

6) Check to see if creating the table has the correct information (may crash here depending on order of parameters).

[Robert Whitley]

Refs #4307. Add warning message when parameters don't match.

Populate the table with workspaces that contain the same parameters.

Changeset: 58d16ac4652c506c74300d8ea1e6c8fa62ed6770

[Robert Whitley]

Refs #4307. Add warning message when parameters don't match.

Populate the table with workspaces that contain the same parameters.

Changeset: 58d16ac4652c506c74300d8ea1e6c8fa62ed6770

[Anders Markvardsen]

Test using linearbackground and emu data

[Stuart Campbell]

This ticket has been transferred to github issue ​5154