Ticket #11736: MASKSANS2D_094i_RKH_withExtraLength_V2.txt

File MASKSANS2D_094i_RKH_withExtraLength_V2.txt, 1.5 KB (added by Anton Piccardo-Selg, 5 years ago)
Line 
1MASK/CLEAR
2MASK/CLEAR/TIME
3DET/FRONT
4GRAVITY/LEXTRA=1.2
5GRAVITY/ON
6L/WAV 4.6 12.85 0.125/LIN
7FIT/TRANS/LOG 4.6 12.85
8L/Q .0018, .0003, .01, -.06, 0.1, 0.006, 0.15
9L/QXY 0 0.04 .002/lin
10!BACK/MON/TIMES 80800 98000
11mask h0
12mask h190>h191
13mask v0
14mask v191
15! try this box mask for the streak below beam stop
16mask h58>h64+v125>v130
17!
18!mask/time 14876 17124
19!mask/time 5000 19200
20!
21L/R 41 -1 3
22!L/SP 1 36864
23!MON/LENGTH=17.937 2
24MON/DIRECT=DIRECT_RUN524.dat
25!MON/FLAT=LOQ$DISK0:[LOQMGR.EFFIC]FLAT_CELL.061
26!
27! this centre found RKH 28/11/09 11m front at -100, why is x centre so different ???
28!  run 2403 gave -308 -228.5 but anisotropic ??  gdw20 run 2407 -310.5 -220.5
29!  run 2459 seems more isotropic gave -308.7 -225.2
30! 9/4/10 try again, with gravity, run 2459  -308.5, -198.8
31set centre -308.7 -198.8 5.1 5.1
32!
33! 29/11/09 INTERIM fit 2448  4.6-12.85, 11m, A1=12, A2=5  (need detail overlap check yet)
34! still need a good centre
35set scales 0.2514 1.0 1.0 1.0 1.0
36!
37! correction to actual sample position, 81-47 for steam header, zero corr is 81mm before safety shutter
38SAMPLE/OFFSET 34.0
39! Correction to SANS2D encoders in mm
40DET/CORR REAR X -16.0
41DET/CORR REAR Z 58.0
42DET/CORR FRONT X -44.0
43DET/CORR FRONT Y -20.0
44DET/CORR FRONT Z 47.0
45DET/CORR FRONT ROT 0.0
46DET/CORR/FRONT/RADIUS 1.0
47DET/CORR/FRONT/SIDE 1.0
48!
49!! 29/11/09  Bouchard, front det only, at 11m,   A2=5mm runs, det moved 25mm
50!! scale from fit to .0098 to .334, 6% log bin data, using 1/data wts as errors too large
51!! beware front det will need its own mask