Ticket #1323: MASKSANS2D_112H_4m_Lu_stopflow.txt

File MASKSANS2D_112H_4m_Lu_stopflow.txt, 1.4 KB (added by Anders Markvardsen, 9 years ago)

Demo user file provided by Sarah

Line 
1PRINT if starting a new 4m mask use the new DIRECT_6958_4m_09Aug11.dat file
2! L1=L2=4m, A1=20, A2=8  SANS/LARGE
3MASK/CLEAR
4MASK/CLEAR/TIME
5L/WAV 1.75 16.5 0.05/LOG
6! strong scatter
7!L/Q .004 1. .08/LOG
8PRINT some WIDE Q bins for weak signals
9! weak scatter
10L/Q 0.004, 0.001, 0.01, -0.15, 1.0
11L/QXY 0 0.025 .005/lin
12! note increase lower time limit here
13BACK/MON/TIMES 85000 98000
14DET/REAR
15GRAVITY/ON
16mask h0
17mask h190>h191
18mask v0
19mask v191
20! dead wire near top
21mask h156>h159
22! spot on rhs beam stop at 11m
23! mask h57>h66+v134>v141
24!
25mask/time 13000 15250
26!mask/time 5000 19200
27!
28L/R 41 -1 3
29!L/SP 1 36864
30!MON/LENGTH=17.937 2
31!
32! 6 May direct beam improves overlap (based on polymer std)
33MON/DIRECT=DIRECT_RUN524_4m_06May11.dat
34MON/TRANS/SPECTRUM=2/INTERPOLATE
35!  set monitor 2 to interpolate
36! PRINT  scale not sorted yet !!
37MON/SPECTRUM=2/INTERPOLATE
38FIT/TRANS/LOG 1.75 16.5
39!
40! 29/07/11 this centre found from gw20 9528
41set centre 175.6 -168.8
42!
43! 29/07/11 gdw20 9528
44set scales 0.1845 1.0 1.0 1.0 1.0
45! correction to actual sample position, measured 115 before shutter, notionally 81mm before shutter
46SAMPLE/OFFSET -34
47! Correction to SANS2D encoders in mm
48DET/CORR REAR X -16.0
49DET/CORR REAR Z 58.0
50DET/CORR FRONT X -44.0
51DET/CORR FRONT Y -20.0
52DET/CORR FRONT Z 47.0
53DET/CORR FRONT ROT 0.0
54!
55!! 29/07/11 MASKSANS2D.112H_4m_Lu stop flow (scale gdw with changer, offset above for stop flow)