Ticket #4357 (closed: fixed)

Opened 9 years ago

Last modified 5 years ago

SANS: picking a none disc sample gives nonsense

Reported by: Anders Markvardsen Owned by: Anders Markvardsen
Priority: critical Milestone: Release 2.0
Component: MantidPlot Keywords:
Cc: Blocked By:
Blocking: Tester: Michael Reuter

Description

In Geometry tab selecting a none disc sample and height is ignored

Change History

comment:1 Changed 9 years ago by Anders Markvardsen

Make sans gui work for none disc samples. re #4357

Changeset: 0028606511104252d81a94e84c503caa7da03c38

comment:2 Changed 9 years ago by Anders Markvardsen

  • Status changed from new to accepted

comment:3 Changed 9 years ago by Anders Markvardsen

  • Status changed from accepted to verify
  • Resolution set to fixed

To test e.g. load ISIS sans mask file systemtests/Data/LOQ/MASK.094AA and in Scattering->Sample box: systemtests/Data/LOQ/LOQ54431.raw

1) run Load Data

2) Go to geometry tab and select Geometry 2: Flat Plate (or 1: Cylinder)

3) run 1D Reduce.

4) Plot workspace 54431main_1D_2.2_10.0

5) Make a note of the maximum y value of the graph

6) go to geometry tab and select a Height(mm) which is half of the current height

7) go back to the Run Numbers tab and run 1D reduce

8) After finished the 1D reduce you should see that the y-values of the graph plotted in 4) has doubled

comment:4 Changed 9 years ago by Michael Reuter

  • Status changed from verify to verifying
  • Tester set to Michael Reuter

comment:5 Changed 9 years ago by Michael Reuter

  • Status changed from verifying to closed

Following the above prescription, I do see that the maximum y for the plot does increase by a factor of 2.

comment:6 Changed 5 years ago by Stuart Campbell

This ticket has been transferred to github issue 5204

Note: See TracTickets for help on using tickets.